Cisco
TelePresence
ISDN
Link
Administrator
Guide
D14954.04 ISDN Link Administrator Guide IL1.1.2, MARCH 2015.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
19
Making a call using the remote
control
If your telePresence endpoint has a remote control, see
the dialing example on this page.
About the ISDN number
• the
ISDN number
is the number to the far end
endpoint (for example an MXP codec).
Replace the number used in the example (8000) with
the number you want to call.
About restricted calls
If using the
Restrict
option, choose the
ISDN Restrict
in the
Call settings menu.
6. Press
(call) to connect the
call. Connecting the call may
take a few seconds. A message
will show on screen while the
call is connecting.
Connecting the call may take up
to 30 seconds.
How to make the call
Press any button on the remote control to wake up the
system.
1. Press
(home) button to open the
Home
menu.
2. Press (right arrow) to open the
Call
menu.
3. use the numeric pad and enter the
ISDN number
you
want to call.
If the default call protocol is set to ISDN (H320), proceed
to
Step 6
, else proceed to
Step 4
.
4
5
6
3
(ok)
(home)
(right arrow)
(call)
1
2
4. Press the fifth soft button to display the
Call Type
menu.
use the arrow keys to navigate and choose
ISDN
.
Press
(ok)
to confirm your selection.
5. Press the fourth soft button to display the
Call Rate
menu.
use the arrow keys to navigate and choose the
call rate
. If
dialing a telephone number, choose
Audio Only
.
Press (ok) to confirm your selection.
(ok)
Contents
Introduction
Getting started
Software upgrade
Status information
System settings
Appendices
Getting started
