Cisco Sx350, Руководство CLI

Страница: 34 / 1323

Introduction
33 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
1
STEP 1
Click Start, then select All Programs > Accessories > Command Prompt to open a
command prompt.
Figure 1 Start > All Programs > Accessories > Command Prompt
STEP 2
At the prompt, enter telnet 1<IP address of switch>, then press Enter.
Figure 2 Command Prompt
STEP 3
CLI will be displayed.
CLI Command Conventions
When entering commands there are certain command entry standards that apply
to all commands. The following table describes the command conventions.
Convention
Description
[ ]
In a command line, square brackets indicate an optional entry.
{ }
In a command line, curly brackets indicate a selection of
compulsory parameters separated the | character. One option must
be selected. For example, flowcontrol {auto|on|off} means that for
the flowcontrol command, either auto, on, or off must be selected.