Cisco Sx350, Руководство CLI

Страница: 134 / 1323

Address Table Commands
133 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4
•
ethernet
interface-list
—(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces; use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
The following example registers a source IP address - Multicast IP address pair to
the bridge table:
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast source 13.16.1.1 group 239.2.2.2
4.8 bridge multicast forbidden source group
To forbid adding or removing a specific IP source address - Multicast address pair
to or from specific ports, use the bridge multicast forbidden source group
IInterface (VLAN) Configuration mode command. To return to the default
configuration, use the no form of this command.
Syntax
bridge multicast forbidden
source ip-address group ip-multicast-address {add |
remove} {ethernet interface-list | port-channel port-channel-list }
no bridge multicast forbidden source ip-address group ip-multicast-address