Cisco Small Business 300 1.1 Series, Руководство администратора

Страница: 153 / 706

Network Management Protocol (SNMP) Commands
78-20269-01 Command Line Interface Reference Guide 154
10
User Guidelines
This command can be entered multiple times for the same filter record. If an object
identifier is included in two or more lines, later lines take precedence. The
command's logical key is the pair (filter-name, oid-tree).
Example
The following example creates a filter that includes all objects in the MIB-II system
group except for sysServices (System 7) and all objects for interface 1 in the
MIB-II interfaces group.
Console(config)# snmp-server filter f1 system included
Console(config)# snmp-server filter f2 system.7 excluded
Console(config)# snmp-server filter f3 ifEntry.*.1 included
10.7 snmp-server host
Use the snmp-server host Global Configuration mode command to specify the
recipient of a Simple Network Management Protocol notification operation. Use
the no form of this command to remove the specified host.
Syntax
snmp-server host {ipv4-address | ipv6-address| hostname} [traps | informs] [version
{1 | 2c | 3 [auth | noauth | priv]}] community-string [udp-port port] [filter filtername]
[timeout seconds] [retries retries]
no snmp-server host {ipv4-address | ipv6-address| hostname} [traps | informs]
[version {1 | 2c | 3}]
Parameters
•
pv4-address—IPv4 address of the host (the targeted recipient).
•
ipv6-address—Pv6 address of the host (the targeted recipient). When the
IPv6 address is a Link Local address (IPv6Z address), the outgoing interface
name must be specified. Refer to the User Guidelines for the interface name
syntax.
•
hostname—Hostname of the host. (Range: 1–158 characters. Maximum
label size: 63)
•
trap—Sends SNMP traps to this host (default).