Cisco Small Business 200, Руководство администратора

Страница: 251 / 351

IP Configuration
IPv4 Management and Interfaces
Cisco Small Business 200 Series Smart Switch Administration Guide 238
16
• IPv6 Address —Enter the IPv6 network address assigned to the interface.
The address must be a valid IPv6 address.
• MAC Address —Enter the MAC address mapped to the specified IPv6
address.
STEP 5
Click Apply . The Running Configuration file is updated.
STEP 6
To change the type of an IP address from Dynamic to Static , select the address,
click Edit and use the Edit IPv6 Neighbors page.
Viewing IPv6 Route Tables
The IPv6 Forwarding Table contains the various routes that have been configured.
One of these routes is a default route (IPv6 address:0) that uses the default router
selected from the IPv6 Default Router List to send packets to destination devices
that are not in the same IPv6 subnet as the device. In addition to the default route,
the table also contains dynamic routes that are ICMP redirect routes received from
IPv6 routers by using ICMP redirect messages. This could happen when the
default router the device uses is not the router for traffic to which the IPv6 subnets
that the device wants to communicate.
To view IPv6 routes:
STEP 1
Click Administration > Management Interface > IPv6 Routes .
This page displays the following fields:
• IPv6 Address —The IPv6 subnet address.
• Prefix Length —IP route prefix length for the destination IPv6 subnet
address. It is preceded by a forward slash.
• Interface —Interface used to forward the packet.
• Next Hop —Address where the packet is forwarded. Typically, this is the
address of a neighboring router. It can be one of the following types.
- Link Local —An IPv6 interface and IPv6 address that uniquely identifies
hosts on a single network link. A link local address has a prefix of FE80 ,
is not routable, and can be used for communication only on the local