Cisco RV260 series, Руководство администратора

Страница: 87 / 124

Access Rules
Rules can be configured for filtering the packets based on particular parameters like IP address or ports. To
configure the access rules, follow these steps:
Step 1 Select
Firewall > Access Rules
.
Step 2 In the IPv4 or IPv6 Access Rules Table, click Add or select the row and click Edit and enter the following:
Check
Enable
to enable the specific access rule. Uncheck to disable.
Rule Status
Choose Allow or Deny from the drop-down list. Action
• IPv4 – Select the service to apply IPv4 rule.
• IPv6 – Select the service to apply IPv6 rule.
•
Services
– Select the service from the drop-down list.
Services
Select an option from the drop-down list.
• Always – Logs appear for packet that matches the rules.
• Never – No log required.
Log
Select the source interface from the drop-down list. Source Interface
Select the source IP address to which the rule is applied and enter the following:
• Any – Select to match all IP addresses
• Single – Enter an IP address.
•
Subnet
– Enter a subnet of a network.
• IP Range – Enter the range of IP addresses.
Source Address
Select the source interface from the drop-down list. Destination Interface
Select the source IP address to which the rule is applied and enter the following:
• Any – Select to match all IP addresses
• Single – Enter an IP address.
• Subnet – Enter a subnet of a network.
•
IP Range
– Enter the range of IP addresses.
Destination Address
Select Always, Business, Evening hours, Marketing, or Work hours from the
drop-down list to apply the firewall rule. Then, click here to configure the schedules.
Schedule Name
Step 3 Click
Apply
.
Step 4 Click Restore Defaults , to restore the default settings.
Step 5
Click Service Management .
RV260x Administration Guide
79
Firewall
Access Rules