Cisco RV260 series, Руководство администратора

Страница: 105 / 124

Check Split DNS to enable.
Splits the DNS server and other DNS requests to another DNS server, based on specified
domain names. When the router receives an address resolution request, it inspects the
domain name. If the domain name matches a domain name in the Split DNS settings, it
passes the request to the specified DNS server. Otherwise, the request is passed to the
DNS server that is specified in the WAN interface settings.
DNS Server 1 and DNS Server 2 – Enter the IP address of the DNS server to use for
the specified domains. Optionally, specify a secondary DNS server in the DNS Server
2 field.
Domain Name 1 to 6 – Enter the domain names for the DNS servers. Requests for the
domains are passed to the specified DNS server.
Split DNS
Step 3 To enable the Site-to-Site Failover, the Keepalive must be enabled on the Advanced Settings tab. Next, on the Failover
tab, provide the following information:
Check
Tunnel Backup
to enable. When the primary tunnel is down, this feature enables
the router to re-establish the VPN tunnel by using either an alternate IP address for the
remote peer or an alternate local WAN. This feature is available only if DPD is enabled.
Tunnel Backup
Enter the IP address for the remote peer, or reenter the WAN IP address that was already
set for the remote gateway. Remote Backup IP Address
Select the local interface ( WAN1, WAN2, USB1, or USB2 ) from the drop-down list. Local Interface
Step 4 Click
Apply
.
Client to Site
Clients from the Internet can connect to the server to access the corporate network or a LAN behind the server.
This feature creates a new VPN tunnel to allow teleworkers and business travelers to access your network by
using third-party VPN client software.
To create and configure the Client-to-Site, follow these steps:
Step 1
Click VPN > IPSec VPN > Client-to-Site .
Step 2 In the IPSec Client-to-Site Tunnels section, click
Add
to add a new tunnel.
Step 3 Click on the Basic Settings tab and configure the following:
Check
Enable
to enable the tunnel.
Enable
Enter a name for the tunnel. Tunnel Name
Select a profile from the drop-down list. IPSec Profile
Select the interface from the drop-down list. Interface
RV260x Administration Guide
97
VPN
Client to Site