Firewall
Access Rules Configuration
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
92
5
Access Rules Configuration
Configuring the Default Outbound Policy
The
Access Rules
page allows you to configure the default outbound policy for
the traffic that is directed from the secure network (LAN) to the non-secure
network (dedicated WAN/optional).
The default inbound policy for traffic flowing from the non-secure zone to the
secure zone is always blocked and cannot be changed.
NOTE
Internet access policies override access rules, when both are configured on the
device.
To configure the default outbound policy:
STEP 1
Select
Firewall
>
Access Rules
.
STEP 2
Select
Allow
or
Deny
.
NOTE
Ensure that IPv6 support is enabled on the device to configure an IPv6 firewall.
STEP 3
Click
Save
.
Reordering Access Rules
The order in which access rules are displayed in the access rules table indicates
the order in which the rules are applied. You may want to reorder the table to have
certain rules applied before other rules. For example, you may want to apply a rule
allowing certain types of traffic before blocking other types of traffic.
To reorder access rules:
STEP 1
Select
Firewall > Access Rules
.
STEP 2
Click
Reorder
.
STEP 3
Check the box in the row of the rule that you want to move up or down and click
the up or down arrow to move the rule up or down one line, or select the desired
position of the rule in the drop-down list and click
Move to
.
STEP 4
Click
Save
.
