Cisco ONS 15454 SDH, Руководство по процедурам

Страница: 630 / 860

19-32
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 19 DLPs D200 to D299
DLP- D234 Roll the Source or Destination of One Optical Circuit
Figure 19-7 Selecting a New Endpoint
Step 10 Click Finish . On the Circuits tab, the circuit status for the Roll From port changes from DISCOVERED
to ROLL_PENDING.
Step 11
Click the Rolls tab ( Figure 19-8 ). For the pending roll, view the Roll Valid Signal status. When one of
the following conditions is met, continue with Step 12 .
• If the Roll Valid Signal status is true, a valid signal was found on the new port.
•
If the Roll Valid Signal status is false, a valid signal was not found. Wait until the signal is found
before continuing with the next step. If the signal is not found, refer to the Circuits and Timing
section of the
Cisco ONS 15454 SDH Troubleshooting Guide . To cancel the roll, see the “DLP-D240
Cancel a Roll” task on page 19-43 .
• The roll is a one-way destination roll and the Roll Valid Signal is false. It is not possible to get a
Roll Valid Signal status of true for a one-way destination roll.
Note You cannot cancel an automatic roll after a valid signal is found.
• You can force a signal onto the Roll To circuit by using the Force Valid Signal button. If you choose
Force Valid Signal, traffic on the circuit that is involved in the roll might drop depending on
conditions at the other end of the circuit when the roll is completed. You must force a signal if the
circuits do not have a signal or have a bad signal and you want to complete the roll.
Note
For a one-way destination roll in manual mode, you do not need to force the valid signal.
HOP
HOP
VC4-*
VC4
134352