Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 505 / 632

18-5
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 18 DLPs H200 to H299
Step 1
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2 Click the static entry that you want to delete.
Step 3
Click Delete Static Entry .
Step 4 In the Delete TDC Entry dialog box, click Yes .
Step 5
Return to your originating procedure (NTP).
DLP-H204 Add a TARP Manual Adjacency Table Entry
Step 1
In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 2 Click Add .
Step 3
In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
•
Level—Sets the TARP Type Code that will be sent:
–
Level 1 —Indicates that the adjacency is within the same area as the current node. The entry
generates Type 1 PDUs.
– Level 2 —Indicates that the adjacency is in a different area than the current node. The entry
generates Type 2 PDUs.
•
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step 4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Entry dialog box.
Step 5
Return to your originating procedure (NTP).
Purpose This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15310-MA SDH must communicate
across routers or non-SDH NEs that lack TARP capability.
Tools/Equipment None
Prerequisite procedures DLP-H29 Log into CTC, page 16-43
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher