Cisco ONS 15310-MA SDH, Руководство по процедурам, Страница: 490 / 632

17-84
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
Step 16
Return to your originating procedure (NTP).
DLP-H188 Delete a Roll
Step 1 From the View menu, choose Go To Network View .
Step 2
Click the Circuits > Rolls tabs.
Step 3 Click the rolled circuit that you want to delete.
Step 4
From the Tools menu, choose Circuits > Delete Rolls.
Step 5
In the confirmation dialog box, click Yes .
Step 6
Return to your originating procedure (NTP).
DLP-H189 Cancel a Roll
Purpose This task deletes a roll. Use caution when selecting this option, traffic may
be affected. Delete a roll only if it cannot be completed or cancelled in
normal ways. Circuits may have a PARTIAL status when this option is
selected. See
Table 17-5 on page 17-10 for a description of circuit statuses.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
NTP-H129 Bridge and Roll Traffic, page 6-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task cancels a roll. When the roll mode is Manual, you can only cancel
a roll before you click the Complete button. When the roll mode is Auto,
cancel roll is only allowed before a good signal is detected by the node or
before clicking the Force Valid Signal button. A dual or single roll can be
cancelled before the roll state changes to ROLL_COMPLETED.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
NTP-H129 Bridge and Roll Traffic, page 6-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher