Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 432 / 632

17-26
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
Step 1
Obtain the original IP address of the node in question.
Step 2 From the View menu, choose Go to Network View .
Step 3
From the Tools menu, choose Overhead Circuits > Repair IP Circuits .
Step 4 Review the text in the IP Repair wizard and click Next .
Step 5
In the Node IP address area, complete the following:
• Node—Choose the node that has an OOS-PARTIAL circuit.
•
Old IP Address—Type the node’s original IP address.
Step 6 Click Next .
Step 7
Click Finish .
Step 8 Return to your originating procedure (NTP).
DLP-H120 Delete Overhead Circuits
Caution Deleting overhead circuits is service affecting if the circuits are in service (unlocked). To put circuits out
of service (OOS), see the
“DLP-H50 Change the Service State for a Port” task on page 16-67 .
Step 1 From the View menu, choose Go to Network View .
Step 2
Click the Provisioning > Overhead Circuits tabs.
Step 3
Click the overhead circuit that you want to delete: user data, IP-encapsulated tunnel, or DCC tunnel.
Step 4
Click Delete .
Step 5
In the confirmation dialog box, click Yes to continue.
Step 6
Return to your originating procedure (NTP).
Purpose This task deletes overhead circuits. Overhead circuits include DCC
tunnels, IP-encapsulated tunnels, and user data channels.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher