Cisco ONS 15310-MA SDH, Руководство по процедурам, Страница: 430 / 632

17-24
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
DLP-H117 Delete a Member from a VCAT Circuit
Caution
Deleting a member from a non-LCAS circuit can be service-affecting.
Caution
Deleting LCAS members in the unlocked-enabled or unlocked-disabled,automaticInService service
state can be service affecting. Cisco recommends putting the LCAS member to be deleted in the
locked-enabled,outOfGroup service state before deleting. Non-LCAS members do not support the
locked-enabled,outOfGroup service state.
Step 1
In node or network view, click the Circuits tab.
Step 2 Click the VCAT circuit that you want to edit, then click Edit .
Step 3
Click the Members tab.
Step 4
Select the member that you want to delete. To select multiple members, press Ctrl and click the desired
members.
Step 5
Click Delete Member .
You cannot delete members from VCAT circuits that use ONS 15454 ML-Series cards as a circuit source
or destination.
Step 6
In the confirmation dialog box, click Yes .
Step 7 Return to your originating procedure (NTP).
Purpose This task removes a member from a non-LCAS or LCAS VCAT circuit on
CE-100T-8, CE-MR-6, or ML-100T-8 cards. This task reduces the size of
the VCAT circuit. You cannot delete members from VCAT circuits that use
ONS 15454 ML-Series cards as a circuit source or destination.
Tools/Equipment CE-100T-8, CE-MR-6, or ML-100T-8 card
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
VCAT circuits must exist on the network. See Chapter 5, “Create Circuits
and VC Low-order Path Tunnels” for circuit creation procedures.
As necessary, complete the “DLP-H180 Change a VCAT Member Service
State” task on page 17-70 to change a LCAS member state to
locked-enabled,outOfGroup.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher