Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 354 / 632

16-64
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 16 DLPs H1 to H99
•
Quality of RES—Not relevant to internal timing; ignore this field.
• Revertive—Not relevant to internal timing; ignore this field.
•
Reversion Time—Not relevant to internal timing; ignore this field.
Step 3 In the Reference Lists area, enter the following information:
•
NE Reference
– Ref 1—Set to Internal Clock.
–
Ref 2—Set to Internal Clock.
– Ref 3—Set to Internal Clock.
•
BITS 1 Out—Set to None.
Step 4 Click Apply .
Step 5
In node view, click the Provisioning > Timing > BITS Facilities tabs.
Step 6 In the BITS In State drop-down list, change State to OOS . Disregard the other BITS Facilities settings;
they are not relevant to internal timing.
Step 7
Click Apply .
Step 8 Return to your originating procedure (NTP).
DLP-H47 Provision a Proxy Tunnel
Note If the SOCKS proxy server is disabled, you cannot set up a proxy tunnel.
Step 1
Click the Provisioning > Network > Proxy subtabs.
Step 2
Click Create .
Step 3 In the Create Tunnel dialog box, complete the following:
•
Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other
length).
• Source Length—Choose the length of the source subnet mask.
Purpose This task sets up a proxy tunnel to communicate with a non-ONS far-end
node. Proxy tunnels are only necessary when the SOCKS proxy server is
enabled and a foreign DCC termination exists, or if static routes exist so
that the DCC network is used to access remote networks or devices. You
can provision a maximum of 12 proxy server tunnels.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
DLP-H52 Provision Section DCC Terminations, page 16-68
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only