Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 348 / 632

16-58
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 16 DLPs H1 to H99
•
Range Address—Enter the area IP address for the ONS 15310-MA SDH nodes that reside
within the OSPF area. For example, if the ONS 15310 OSPF area includes nodes with IP
addresses 10.10.20.100, 10.10.30.150, 10.10.40.200, and 10.10.50.250, the range address
would be 10.10.0.0.
• Range Area ID—Enter the OSPF area ID for the ONS 15310-MA SDH nodes. This is either the
ID in the DCC OSPF Area ID field or the ID in the Area ID for LAN Port field.
•
Mask Length—Enter the subnet mask length. In the Range Address example, this is 16.
• Mask—The static route subnet mask value.
•
Advertise—Check if you want to advertise the OSPF range table.
c. Click OK .
Step 7
If the ONS 15310-MA SDH OSPF area is not physically connected to Area 0, use the following steps to
create a virtual link table that will provide the disconnected area with a logical path to Area 0:
a. Under OSPF Virtual Link Table, click Create .
b.
In the Create Virtual Link dialog box, complete the following fields (OSPF settings must match
OSPF settings for the ONS 15310 OSPF area):
• Neighbor—The router ID of the Area 0 router.
•
Transmit Delay (sec)—The service speed. One second is the default.
• Retransmit Int (sec)—Sets the time that will elapse before a packet is resent. Five seconds is the
default.
•
Hello Int (sec)—The number of seconds between OSPF hello packet advertisements sent by
OSPF routers. Ten seconds is the default.
• Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router’s packets are
not visible before its neighbors declare the router down. Forty seconds is the default.
•
Auth Type—If the router where the ONS 15310-MA SDH is connected uses authentication,
choose
Simple Password . Otherwise, choose No Authentication .
• Auth Key—If authentication type is set to Simple Password, the authentication key (password)
is listed here.
c.
Click OK .
Step 8 After entering ONS 15310-MA SDH OSPF area data, click Apply .
Step 9
Return to your originating procedure (NTP).