Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 87 / 136

C H A P T E R
4-1
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
4
Turn Up and Test
This chapter describes the turn up and test procedures for the ONS 15200 system. This chapter includes
the ONS 15252 Multichannel Unit (MCU) turnup, the ONS 15201 Single-Channel Unit (SCU) turnup,
and the system span test.
Appendix B, “Acceptance Test Plan” contains the tables and forms that you
must complete during system turn up and testing.
After adding channels to the ONS 15200 system configuration, test the added channels using the
procedures in the
“Perform System Span Testing for a Hub Configuration” section on page 4-19 .
4.1 Equipment
You need the following equipment to turn up and test the ONS 15200 system:
•
Optical power meter
• Bit error rate (BER) test equipment with OC-48 signal transmit or other bit rate
•
Gigabit Ethernet signal generator (optional; use if required by customer)
• 5- and 10-dB fixed optical attenuators with SC connectors
•
Optical fiber jumper cables with SC connectors
• Wavelength meter or optical spectrum analyzer (OSA)
•
Communication Interface Module (CIM) RS-232 cable (P/N 72-2746) for initial communication
with the Network Control Board (NCB) module
• SC and MU fiber cleaning equipment:
–
Cletop cassette cleaner (type A and B recommended)
– Cletop stick cleaner (1.25 and 2.5 mm)
–
SC and MU protective plugs and caps
– Fiber inspection microscope
–
Patch cord MU-MU (2)
– Patch cord MU-SC (2)
–
Optical adapter SC simplex (2)
– Optical adapter MU simplex (2)
•
To manage an SCU, Maintenance Manager software and hardware (P/N 800-16721) installed on a
PC