Removing a PCIe Node Cover
To remove the cover of the Cisco UCS X440p PCIe Node, follow these steps:
Step 1
Press and hold the button down (1, in the figure below).
Step 2
While holding the back end of the cover, slide it back, then pull it up (2).
By sliding the cover back, you enable the front edge to clear the metal lip on the rear of the PCIe node.
Installing a PCIe Node Cover
Use this task to install a removed top cover for the PCIe node.
Step 1
Insert the cover at an angle so that the cutouts on the rear of the catch the guide pins on the inside walls of the node.
Step 2
Lower the PCIe node's cover until it sits on the node.
Step 3
Keeping the PCIe node's cover flat, slide it forward until the release button clicks.
Make sure that the front edge of the top cover slides under the metal edge of the node. If you feel resistance,
these two edges might be making contact instead of sitting on top of each other.
Note
Cisco UCS X440p PCIe Node Installation and Service Guide
18
Servicing the Cisco UCS X440p PCIe Node
Removing a PCIe Node Cover
