S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
9-29
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing an I/O Module
Figure 9-11
Repacking an 8- or 48-Port I/O Module (N7K-M108X2-12L, N7K-M148GT-11,
N7K-M148GT-11L, N7K-M148GS-11, or N7K-M148GS-11L)
1
Put the module in an ESD bag.
7
Tape the flap to the box.
2
Place the bagged module on the foam pad.
8
Insert the two box sides into foam blocks.
3
Attach a side pad to each of the long sides of
the module.
9
Place the box and its foam blocks into the
larger box.
4
Fold the side flaps up along the side pads.
10
Fold the narrow flaps over the smaller box and
foam blocks.
5
Fold the long flaps up along the ends of the
module and then over the top of the module.
Insert the two tabs on each flap into the side
flaps.
11
Fold the wide flaps over the box.
6
Insert the folded box into the slightly larger
box.
12
Tape the wide flaps together and to the box.