Cisco Nexus 7000 Series, Справочник по командам

Страница: 711 / 1018

switchport port-security violation
To configure the action that the device takes when a security violation event occurs on an interface, use the
switchport port-security violation command. To remove the port security violation action configuration,
use the no form of this command.
switchport port-security violation { protect| restrict| shutdown }
no switchport port-security violation
{
protect| restrict| shutdown
}
Syntax Description
Specifies that the device does not raise security
violations when a packet would normally trigger a
security violation event. Instead, the address that
triggered the security violation is learned but any
traffic from the address is dropped. Further address
learning stops. protect
Specifies that the device drops ingress traffic from
any nonsecure MAC addresses. Address learning
continues until 100 security violations have occurred
on the interface. Traffic from addresses learned after
the first security violation is dropped.
After 100 security violations occur, the device
disables learning on the interface and drops all ingress
traffic from nonsecure MAC addresses. In addition,
the device generates an SNMP trap for each security
violation.
restrict
Specifies that the device shuts down the interface if
it receives a packet triggering a security violation.
The interface is error disabled. This action is the
default. After you reenable the interface, it retains its
port security configuration, including its secure MAC
addresses. shutdown
Command Default
None
Command Modes
Interface configuration
Command History
Modification Release
Support for Layer 2 port-channel interfaces was added. 4.2(1)
This command was introduced. 4.0(1)
Cisco Nexus 7000 Series Security Command Reference
685
S Commands
switchport port-security violation