Cisco Nexus 3548 series, Справочник по командам

Страница: 417 / 556

397
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
vrf context (Layer 2)
vrf context (Layer 2)
To create a virtual routing and forwarding (VRF) instance and enter VRF configuration mode, use the
vrf context command. To remove a VRF entry, use the no form of this command.
vrf context { name | management }
no vrf context { name | management }
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines When you enter the VRF configuration mode, the following commands are available:
•
exit —Exits from the current command mode.
•
ip —Enables configuration of IP features.
Additional commands available in IP configuration mode:
–
domain-list —Adds additional domain names.
–
domain-lookup —Enables or disables DNS lookup.
–
domain-name —Specifies the default domain name.
–
host —Adds an entry to the IP hostname table.
–
name-server —Specifies the IP address of a DNS name server.
– route —Adds route information by specifying IP addresses of the next hop servers.
•
no —Negates a command or set its defaults.
•
shutdown —Shuts down the current VRF context.
This command does not require a license.
Examples This example shows how to enter VRF context mode:
switch# configure terminal
switch(config)# vrf context management
switch(config-vrf)#
name Name of the VRF. The name can be a maximum of 32 alphanumeric
characters and is case sensitive.
management Specifies the management VRF.
Release Modification
5.0(3)A1(1) This command was introduced.