Cisco Nexus 3548 series, Справочник по командам

Страница: 116 / 556

96
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
client-to-client reflection
client-to-client reflection
To enable or restore route reflection from a Border Gateway Protocol (BGP) route reflector to clients,
use the
client-to-client reflection command. To disable client-to-client route reflection, use the no form
of this command.
client-to-client reflection
no client-to-client reflection
Syntax Description This command has no arguments or keywords.
Command Default Client-to-client route reflection is enabled by default; when a route reflector is configured, the route
reflector reflects routes from a client to other clients.
Command Modes Router address-family configuration mode
Command History
Usage Guidelines
By default, the clients of a route reflector are not required to be fully meshed and the routes from a client
are reflected to other clients. However, if the clients are fully meshed, route reflection is not required. In
this case, use the
no client-to-client reflection command to disable client-to-client reflection.
This command requires the LAN Enterprise Services license.
Examples This example shows how to configure a router as a route reflector:
switch# configure terminal
switch(config)# router bgp 50000
switch(config-router)#
address-family ipv4 multicast
switch(config-router-af)# client-to-client reflection
switch(config-router-af)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family (BGP
router) Places the router in address family configuration mode for configuring
routing sessions that use standard IPv4 address prefixes.
show ip bgp Displays entries in the BGP routing table.