Front Panel Ports
The section describes the front panel ports for the SC-SW and SC cards.
Figure 43: SC-SW Front Panel Ports
USB 2.0 port
5
Two 10GE expansion ports (EXP 0 and EXP 1)
1
Two QSFP+ 40GE optical ports (HS0 and HS1)
6
DB15 connector alarm port
2
56 SFP+ 10GE optical ports, left to right(0
through 27 on bottom, 28 though 55 on top)
7
Two EIA232 serial console ports: (CON 0 and
CON1)
3
RJ-45 Ethernet management port
4
The Shelf-Controller (SC) external ports include:
•
10GE expansion ports: used to expand the internal control Ethernet network to the LCC by connecting
through the SW switch ports. The ports are identical in functionality. Each port is capable of 10GE
operation via SFP+ modules. The SFP+ modules supported are: SFP+10GE-L and SFP+10GE-S.
•
DB15 connector: Alarm port that uses a standard DB15 connector.
•
EIA-232 serial console ports.
•
RJ-45 Ethernet management port: RJ-45 copper10/100/1000 Mbps full duplex port.
•
USB2.0 port (type A receptacle): used to attach storage device to the FCC. This USB port is used only
for storage devices.
•
QSFP+ 40GE optical ports: Quad Small-Form-factor Pluggable (QSFP) 40GE ports used for
communication between the FCC and Route Processor (RP) cards on the LCC.
•
SFP+ 10GE optical ports: controls plane connectivity between the FCC and the LCC.
The Switch (SW) external ports include:
•
56 SFP+ 10GE ports: controls the plane connectivity between the FCC and the LCC and two 40GE
ports.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
70
Installing the Shelf Controller Cards and Fabric Cards
Front Panel Ports
