controller coherentDSP
To configure the coherent DSP controller, use the
controller coherentDSP
command in the Coherent DSP
controller configuration mode.
controller coherentDSP
R/S/I/P
[
description
]
| [
fec
fec-value
] | [
pm
{
30-sec
|15-min | 24-hour
} {
fec | otn
} {
report | threshold
}
value
] | [
perf-mon
{
enable
|
disable
} ] | [
loopback internal
] | [
secondary-admin-state
{
maintenance | normal
}] | [
shutdown
] | [
tti
{
sent | expected
}
{
ascii | hex
}
tti-string
][
gcc0
Syntax Description
Rack/Slot/Instance/Port of the coherent DSP controller.
R/S/I/P
Description of the coherent DSP controller.
description description
Configures the FEC on the controller. The supported options on the 1.2T
line card are StandardSD15 and StandardSD27.
fec fec-value
Configures performance monitoring parameters for 30 second,15 minute,
or 24 hour intervals.
The
fec
keyword configures FEC PM data in 30 second, 15 minute, or 24
hour intervals.
The
otn
keyword configures OTN PM data in 30 second, 15 minute, or
24 hour intervals.
The
report
keyword configures TCA reporting status.
The
threshold
keyword configures threshold values on PM parameters.
pm
{
30-sec |15-min | 24-hour
}
{
fec | otn
} {
report |
threshold
}
value
Enables or disables performance monitoring.
perf-mon
{
enable
|
disable
}
Configures the internal loopback mode on the controller.
For the 1.2T line card, internal and line loopbacks are supported on the
Ethernet controllers whereas only internal loopback is supported on the
CoherentDSP controllers.
loopback internal
Configures the administrative state of the controller. The values are
maintenance or normal.
secondary-admin-state
Disables the configuration of the controller.
shutdown
Configures the Trail Trace Identifier (TTI) ASCII or hex string to be sent.
SAPI, DAPI, and operator inputs are not supported.
tti sent {ascii | hex} tti-string
Configures the expected TTI ASCII or hex string. The OTUK-TIM alarm
is raised if the received TTI string does not match the expected TTI string.
SAPI, DAPI, and operator inputs are not supported.
tti expected {ascii | hex}
tti-string
Enables the GCC0 interface.
gcc0
Command Reference for Cisco NCS 1004
9
Commands
controller coherentDSP
