Configure H.323 and SIP
(When not set by a provisioning system)
To get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SIP protocol for video calls.
The diagnostics on your system will indicate if there is a
problem with H.323 or SIP registering.
If you wish to change the other H.323 or SIP settings, see the
administrator guide for your product.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite), your Cisco TMS adminis-
trator will help you to get online.
You can find information about administering through Cisco
UCM in the
Administering CE endpoints on CUCM
guide.
NOTE:
H.323 is not available for the SX10.
H.323
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the
Setup
tab, and select
Configuration
.
2. Open the
H323
settings from the left sidebar.
3. Under the
H323Alias
heading enter the
E164
and the
ID
number in the corresponding input fields.
4. Enter the
Gatekeeper Address
in the corresponding input
field.
5. If the H.323 gatekeeper requires authentication, and you
want your system to authenticate itself to the gatekeeper,
go to the
Authentication
subheading and select
On
in
the
Mode
drop down list. Then enter the
LoginName
and
Password
in the corresponding input fields.
Otherwise, select
Off
in the
Mode
drop down list.
SIP
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the
Setup
tab, and select
Configuration
.
2. Open the
SIP
settings from the left sidebar.
3. Enter the SIP URI in the
URI
input field, and optionally a
display name in the
DisplayName
input field.
4. Select the preferred transport protocol from the
DefaultTransport
drop down list. If you select
Auto
, the
system first tries to connect using Tls, then TCP, and finally
UDP.
5. Select a proxy type in the
Type
drop down list. The default
type is
Standard
. You can use
Cisco
when registering to
CUCM.
6. Enter the
Proxy 1 Address
in the corresponding input field
7. If the SIP proxy requires authentication, you must enter a
login name and password to authenticate your system. Go
to the
Authentication
heading and enter the
LoginName
and
Password
in the corresponding input fields.
If you are changing a value setting,
you have to always click
save
to confirm the change.
Cisco TelePresence Video Systems
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
16
Getting Started Guide
Introduction
User interfaces
Web interface
On-screen setup assistant
Appendices
Touch
Web interface
