3-56
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
Step 9
To display the configuration of the PNNI port, enter the following command:
mgx8830a.1.PXM.a >
dsppnport
<
portid
>
Replace <portid> using the format slot:bay.line:ifNum.
describes these parameters. The
following example shows the report for this command.
mgx8830a.1.PXM.a >
dsppnport
1.35
Port: 1.35 Logical ID: 16845603
IF status: up Admin Status: up
UCSM: enable SVC Routing Pri: 8
Auto-config: enable Addrs-reg: enable
IF-side: network IF-type: uni
UniType: private Version: none
PassAlongCapab: n/a
Input filter: 0 Output filter: 0
minSvccVpi: 0 maxSvccVpi: 0
minSvccVci: 35 maxSvccVci: 0
minSvpcVpi: 1 maxSvpcVpi: 0
(P=Configured Persistent Pep, NP=Non-Persistent Pep, Act=Active)
#Spvc-P: #Spvc-NP: #SpvcAct: #Spvp-P: #Spvp-NP: #SpvpAct:
p2p : 0 0 0 0 0 0
p2mp: 0 0 0 0 0 0
#Svcc: #Svpc: #Ctrl: Total:
p2p : 0 0 0 0
p2mp: 0 0 0 0
Total: 0
Defining Destination Addresses for Static Links
Typically, an AINI or IISP static link joins two independent networks. AINI or IISP links are used
instead of PNNI so that the topologies of the two networks remain unknown to the each other.
When you create a static link, you must identify destination addresses for each side of the link. These
addresses identify which ATM nodes are accessible on the other side of the link. After you define these
addresses, all requests for these addresses are routed over the static link to the other network.
Note
To enable bidirectional call initiation, the appropriate destination address must be configured at each end
of the link. For example, if nodes A and B have PNNI connections to a static link, the ATM address for
Node B must be added to the Node A side of the static link, and the Node A address must be added to
the Node B side of the static link.
To add destination addresses to a static link, use the following procedures.
Step 1
Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2
To locate the port to which you want to add an address, enter the dsppnports command.
Step 3
Specify an ATM address using the following command:
mgx8830a.1.PXM.a >
addaddr
<
portid
> <
atm-addres
s> <
length
>
-type
ext
-proto
static
[
-plan
{
e164
|
nsap
}] [
-scope
scope
] [
-redistribute
{
yes
|
no
}]
