Configuration Wizards
Using the DMZ Wizard to Configure DMZ Settings
Cisco ISA500 Series Integrated Security Appliances Administration Guide
72
2
STEP 5
Enter the following information:
•
Service:
Choose either DynDNS or No-IP service.
NOTE:
You must sign up for an account with either one of these providers
before you can use this service.
•
Active On Startup:
Click
On
to activate the DDNS setting when the security
appliance starts up.
•
WAN Interface:
Choose the WAN port for the DDNS service. Traffic for
DDNS services will pass through the specified WAN port.
NOTE:
If the WAN redundancy is set as the Failover mode, this option is
grayed out. When WAN failover occurs, DDNS will switch traffic to the active
WAN port.
•
User Name:
Enter the username of the account that you registered in the
DDNS provider.
•
Password:
Enter the password of the account that you registered in the
DDNS provider.
•
Host and Domain Name:
Specify the complete host name and domain
name for the DDNS service.
•
Use wildcards:
Check this box to allow all sub-domains of your DDNS host
name to share the same public IP address as the host name.
•
Update every week:
Check this box to update the host information every
week.
STEP 6
Click
OK
to save your settings.
STEP 7
After you are finished, click
Next
.
Configuring DMZ Network
STEP 8
Use the DMZ Configuration page to configure the DMZ networks.
NOTE:
Up to 4 DMZ networks can be configured on the security appliance. You
must configure at least one DMZ network to finish the DMZ wizard.
STEP 9
Click
Add
to create a DMZ network.
Other options:
To edit an entry, click the
Edit
(pencil) icon. To delete an entry, click
the
Delete
(x) icon.
