Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide
40
2
Configuring Remote Administration
STEP 16
Use the Remote Administration page to configure the remote management
settings. The security appliance allows remote management securely by using
HTTPS and HTTP, for example https://xxx.xxx.xxx.xxx:8080.
•
Remote Administration:
Click
On
to enable remote management by using
HTTPS, or click
Off
to disable it. We recommend that you use HTTPS for
secure remote management.
•
HTTPS Listen Port Number:
If you enable remote management by using
HTTPS, enter the port number. By default, the listen port number for HTTPS
is 8080.
•
HTTP Enable:
Click
On
to enable remote management by using HTTP, or
click
Off
to disable it.
•
HTTP Listen Port Number:
If you enable remote management by using
HTTP, enter the port number. By default, the listen port number for HTTP is
80.
•
Allow Address:
To specify the devices that can access the configuration
utility through the WAN interface, choose an Address Object or enter an
address.
-
Address Objects:
These objects represent known IP addresses and
address ranges, such as the GUEST VLAN and the DHCP pool. After
completing the wizard, you can view information about Address Objects
on the Networking > Address Management page.
-
Create new address:
Choose this option to enter an IP address or
address range. In the pop-up window, enter a
Name
and specify the
Type
(Host or Range). For a single host, enter the IP address. For a range,
enter the
Starting IP Address
and the
Ending IP Address
.
•
Remote SNMP:
Click
On
to enable SNMP for remote connection, or click
Off
to disable SNMP. Enabling SNMP allows remote users to use the SNMP
protocol to access the Configuration Utility.
STEP 17
After you are finished, click
Next
.
