Cisco IAD2801 Series, Руководство по установке

Страница: 28 / 79

1-6
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
OL-12433-01
Chapter 1 Overview
Interface Numbering
Figure 1-4 Back Panel of the Cisco IAD2801
Interface Numbering
Table 1-4 summarizes the interface numbering on a Cisco IAD2801.
Note On the Cisco IAD2801, the numbering format for slots is interface type 0/slot/port . “0” indicates slots
that are built into the chassis of a router. On the Cisco IAD2801, all slots begin with “0,” because all
slots are built into the chassis.
Caution The following message will appear during bootup for any unsupported card detected:
Card is not supported in slot 2. Please remove it.
This message will appear for each unsupported card detected.
If smart-init is enabled on your IAD2801, the following message will appear during bootup for any
unsupported card detected:
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0X003AA110 public buffer pools
0X00211000 public particle pools
0X00020000 Crypto module pools
0X00120000 VPM buffer pools
0X05B3 0X000034A0 Card in slot 0
0X04C8 0X00077D00 Card in slot 1
0X05B3 0X00000000 UNKNOWN Card in slot 2
0X003A 0X00000000 Card in slot 3
0X000021B8 Onboard USB
Table 1-4 summarizes the interface numbering on a Cisco IAD2801.
1 Input power connector 3 Chassis ground connection
2
On/Off switch
95905
3
1 2