Getting Started
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 18 of 177
Fluidmesh components in real time, based on an optimal, software-
determined path. In addition, the absence of any single point of failure
greatly increases reliability when compared to any other wireless or wired
data-transmission technology.
Figure 2. Fluidmesh Mesh Networking Architecture
3.3. Fluidmesh network addressing
3.3.1. Bridge IP addressing
If needed, the Cisco FM3500 Endo can be operated in
Bridge mode
. This
creates a single point-to-point connection between two network segments.
A simplified example of a Bridge mode connection is shown in
As shipped from the factory, the wired ethernet ports of all Fluidmesh
hardware components are assigned the same default IP address of
192.168.0.10/24
.
No default IP address is associated with the wireless interface.
