Changing the operational mode
Operational mode settings on a Gateway unit
Since the Cisco FM1000 Gateway is always connected to a wired LAN
backbone, it is capable of operating in
Mesh End
mode only.
A Fluidmesh hardware device that is a junction point between the wireless
network and any IP-based wired network is always set in
Mesh End
mode.
Changing the LAN parameters
The LAN Parameters box (below) contains the entry controls for local-
address setting.
NOTE
When the
General Mode
window is opened for the first time,
the
Local IP
and
Local Netmask
LAN parameters will be
factory-set default values.
The information needed is self-explanatory. To enter a parameter, click the
field and type the parameter.
If needed, enter the local primary DNS address in the
Dns 1
field, and
enter the local secondary DNS address in the
Dns 2
field.
Save the LAN settings by clicking the
Save
button. Alternatively, clear the
settings by clicking the
Reset
button.
6.6. Network control
6.6.1. FM-QUADRO
FM-QUADRO for mesh network-capable devices
The
FMQuadro
window contains controls to do the following functions:
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 53 of 138
