Figure 11: Attaching Brackets for 23-inch Racks (Rear Mounting)
What to do next
Complete the steps in the section
Rack-Mount the Switch, on page 22
Attach Brackets for ETSI Racks
Follow the instructions in this section to attach brackets for ETSI racks.
• 23-inch and ETSI brackets should not be used in high vibration environments, including any railway
application (EN50155).
• If you use ETSI brackets you can insert rubber plugs into switch holes for IP-30 compliance. Insert
them into the same holes as shown in the image Plug Locations by Position in the section
Brackets for 19-Inch Racks for IP-30 Compliance (Optional), on page 18
. Do so before installing
the brackets.
Note
Before you begin
Complete the tasks in the section
.
Attach the brackets to the switch, following the steps in the illustration.
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
21
Switch Installation
Attach Brackets for ETSI Racks