Command or Action
Purpose
Step 5
ATM(lane-config-database)#
nameelan -name2local-seg-
idsegment-number
Assigns a segment number to the second emulated Token Ring LAN in the
configuration database.
The segment number you specify for the local-seg-id keyword must be identical to the
ring number of the TrCRF. The set vlaninterface configuration command assumes that
any ring number you enter is in hexadecimal. The name elan-name local-seg-id
segment-number LANE database configuration command assumes that any value you
enter for the local-seg-id keyword is in decimal unless you enter it explicitly in
hexadecimal.
Repeat this step, providing a different ELAN name and segment number for each
additional source-route bridged ELAN in this switch cloud.
Step 6
ATM(lane-config-database)#
client-atm-addressatm-
address-templatenameelan-
name
Adds a database entry associating a specific client’s ATM address with a specific
restricted-membership ELAN.
Repeat this step for each of the clients of each of the restricted-membership ELANs on
the switch cloud, in each case specifying that client’s ATM address and the name of the
ELAN with which it is linked.
Step 7
ATM(lane-config-database)#
exit
Exits from database configuration mode and returns to global configuration mode.
Binding the LECS to the ATM Interface
Once you have created the database entries as appropriate to the type and the membership conditions of the
ELANs, to enable the LECS on the selected ATM interface and switch, use the following commands
beginning in global configuration mode:
SUMMARY STEPS
1.
ATM(config)# interface atmnumber
2.
ATM(config-if)# lane config auto-config-atm-address
3.
ATM(config-if)# lane config databasedatabase-name
4.
ATM(config-if)# exit
5.
ATM# copy running-config startup-config
DETAILED STEPS
Command or Action
Purpose
Step 1
ATM(config)# interface atmnumber
If you are not currently configuring the interface, specifies the major
ATM interface where the LECS is located and enters interface
configuration mode.
Step 2
ATM(config-if)# lane config auto-config-atm-
address
Specifies that the LECS’s ATM address will be computed by the
automatic method.
Step 3
ATM(config-if)# lane config
databasedatabase-name
Binds the LECS’s database name to the specified major interface, and
enables the LECS.
Binding the LECS to the ATM Interface
Setting Up the Database for Restricted-Membership ELANs
17