Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения

Страница: 902 / 2086

32-4
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 32 Configuring LLDP, LLDP-MED, and Location Service
Configuring LLDP and LLDP-MED, and Location Service
•
Slot, port, and port-type
• Client’s MAC address
•
Client’s IP address
• 802.1X username if applicable
•
Device category is specified as a wired station
• State is specified as Connected
•
Serial number, UDI
• Model number
•
Software version
• VLAN ID and VLAN name
Depending on the device capabilities, the switch obtains this client information at link down:
• Slot and port that was disconnected
•
Client’s MAC address
• Client’s IP address
•
802.1X username if applicable
• Device category is specified as a wired station
•
State is specified as Disconnected
• Serial number, UDI
•
Model number
• Software version
•
VLAN ID and VLAN name
If an administrator changes a location address at the switch, the information is reported to the MSE. The
switch sends a NMSP location notification message that identifies the list of ports affected by the change
and the changed address information.
Configuring LLDP and LLDP-MED, and Location Service
This section contains this configuration information:
•
Default LLDP Configuration, page 32-5
• Configuring LLDP Characteristics, page 32-5
•
Disabling and Enabling LLDP Globally, page 32-6
• Disabling and Enabling LLDP on an Interface, page 32-7
•
Configuring LLDP-MED TLVs, page 32-9
• Configuring Network-Policy Profile, page 32-10
•
Configuring LLDP Power Negotiation, page 32-11
• Configuring Location TLV and Location Service, page 32-12
•
Monitoring and Maintaining LLDP, LLDP-MED, and Location Service, page 32-14