Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения

Страница: 1881 / 2086

75-31
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 75 Configuring Ethernet OAM and CFM
Managing and Displaying Ethernet CFM Information
Use the no form of the commands to return to the default configuration or to remove a configuration. To
disable the generation of ETH-AIS frames, enter the disable config-ais-link-cfm mode command.
This is an example of the output from the show ethernet cfm smep command when Ethernet AIS has
been enabled:
Switch# show ethernet cfm smep
SMEP Settings:
--------------
Interface: GigabitEthernet1/0/3
LCK-Status: Enabled
LCK Period: 60000 (ms)
Level to transmit LCK: Default
AIS-Status: Enabled
AIS Period: 60000 (ms)
Level to transmit AIS: Default
Defect Condition: AIS
Using Multicast Ethernet Loopback
You can use the ping privileged EXEC command to verify bidirectional connectivity of a MEP, as in this
example:
Switch#
ping ethernet multicast domain CD vlan 10
Type escape sequence to abort.
Sending 5 Ethernet CFM loopback messages to 0180.c200.0037, timeout is 5 seconds:
Reply to Multicast request via interface FastEthernet1/0/3, from 001a.a17e.f880, 8 ms
Total Loopback Responses received: 1
Managing and Displaying Ethernet CFM Information
You can use the privileged EXEC commands in these tables to clear Ethernet CFM information.
Step 17
ethernet cfm ais link-status level level-id
Configures the maintenance level for sending AIS frames
transmitted by the SMEP on the interface. The range is 0 to
7.
Step 18
end Returns to privileged EXEC mode.
Step 19
show ethernet cfm smep
[
interface interface-id
]
Verifies the configuration.
Step 20
show ethernet cfm error
Displays received ETH-AIS frames and other errors.
Step 21
copy running-config startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Table 75-1 Clearing CFM Information
Command Purpose
clear ethernet cfm ais domain domain-name
mpid id { vlan vlan-id | port }
Clears MEPs with matching domain and VLAN ID out of AIS defect
condition.
clear ethernet cfm ais link-status
interface interface-id
Clears a SMEP out of AIS defect condition.
clear ethernet cfm error
Clears all CFM error conditions, including AIS.