4-6
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 4 Administering the Switch
Managing the System Time and Date
Configuring NTP Associations
An NTP association can be a peer association (this switch can either synchronize to the other device or
allow the other device to synchronize to it), or it can be a server association (meaning that only this
switch synchronizes to the other device, and not the other way around).
To form an NTP association with another device, perform this task:
You need to configure only one end of an association; the other device can automatically establish the
association. If you are using the default NTP version (Version 3) and NTP synchronization does not
occur, try using NTP Version 2. Many NTP servers on the Internet run Version 2.
To remove a peer or server association, use the
no ntp peer
ip-address
or the
no ntp server
ip-address
global configuration command.
This example shows how to configure the switch to synchronize its system clock with the clock of the
peer at IP address 172.16.22.44 using NTP Version 2:
Switch#
configure terminal
Switch(config)#
ntp server 172.16.22.44 version 2
Switch(config)#
end
Switch#
Command
Purpose
Step 1
configure terminal
Enters global configuration mode.
Step 2
ntp peer
ip-address
[
version
number
]
[
key
keyid
] [
source
interface
]
[
prefer
]
or
ntp server
ip-address
[
version
number
] [
key
keyid
] [
source
interface
] [
prefer
]
Configures the switch system clock to synchronize a peer or to be
synchronized by a peer (peer association).
or
Configures the switch system clock to be synchronized by a time server
(server association).
No peer or server associations are defined by default.
•
For
ip-address
in a peer association, specify either the IP address of
the peer providing, or being provided, the clock synchronization. For
a server association, specify the IP address of the time server
providing the clock synchronization.
•
(Optional) For
number
, specify the NTP version number. The range is
1 to 3. By default, Version 3 is selected.
•
(Optional) For
keyid
, enter the authentication key defined by entering
the
ntp authentication-key
global configuration command.
•
(Optional) For
interface
, specify the interface from which to pick the
IP source address. By default, the source IP address is taken from the
outgoing interface.
•
(Optional) Enter the
prefer
keyword to make this peer or server the
preferred one that provides synchronization. This keyword reduces
switching back and forth between peers and servers.
Step 3
end
Returns to privileged EXEC mode.
Step 4
show running-config
Verifies your entries.
Step 5
copy running-config startup-config
(Optional) Saves your entries in the configuration file.
Содержание Catalyst 4500 Series
Страница 2: ......
Страница 4: ......
Страница 2086: ...Index IN 46 Software Configuration Guide Release IOS XE 3 9 0E and IOS 15 2 5 E ...