Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения

Страница: 1787 / 2086

70-5
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 70 Configuring System Message Logging
Configuring System Message Logging
The logging buffered global configuration command copies logging messages to an internal buffer. The
buffer is circular, so newer messages overwrite older messages after the buffer is full. To display the
messages that are logged in the buffer, use the
show logging privileged EXEC command. The first
message displayed is the oldest message in the buffer. To clear the contents of the buffer, use the
clear logging privileged EXEC command.
To disable logging to the console, use the no logging console global configuration command. To disable
logging to a file, use the no logging file [ severity-level-number | type ] global configuration command.
Synchronizing Log Messages
You can synchronize unsolicited messages and debug privileged EXEC command output with solicited
device output and prompts for a specific console port line or virtual terminal line. You can identify the
types of messages to be output asynchronously based on the level of severity. You can also configure the
maximum number of buffers for storing asynchronous messages for the terminal after which messages
are dropped.
When synchronous logging of unsolicited messages and debug command output is enabled, unsolicited
device output appears on the console or printed after solicited device output appears or printed.
Unsolicited messages and
debug command output appears on the console after the prompt for user input
is returned. Unsolicited messages and debug command output are not interspersed with solicited device
output and prompts. After the unsolicited messages are displayed, the console again displays the user
prompt.
To configure synchronous logging, perform this task:
Step 3
Switch(config)# logging host
Logs messages to a UNIX syslog server host.
For host , specify the name or IP address of the host to be used as the
syslog server.
To build a list of syslog servers that receive logging messages, enter this
command more than once.
For complete syslog server configuration steps, see the “Configuring
UNIX Syslog Servers” section on page 70-10 .
Step 4
Switch(config)# end
Returns to privileged EXEC mode.
Step 5
Switch# terminal monitor
Logs messages to a nonconsole terminal during the current session.
Terminal parameter-setting commands are set locally and do not remain
in effect after the session has ended. You must perform this step for each
session to see the debugging messages.
Step 6
Switch# show running-config
Verifies your entries.
Step 7
Switch# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose