Cisco Catalyst 3650 Series, Справочник по командам

Страница: 83 / 1108

power efficient-ethernet auto
To enable Energy Efficient Ethernet (EEE) for an interface, use the power efficient-ethernet auto command
in interface configuration mode. To disable EEE on an interface, use the no form of this command.
power efficient-ethernet auto
no power efficient-ethernet auto
Syntax Description
This command has no arguments or keywords.
Command Default
EEE is disabled.
Command Modes
Interface configuration
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SE
Usage Guidelines
You can enable EEE on devices that support low power idle (LPI) mode. Such devices can save power by
entering LPI mode during periods of low utilization. In LPI mode, systems on both ends of the link can save
power by shutting down certain services. EEE provides the protocol needed to transition into and out of LPI
mode in a way that is transparent to upper layer protocols and applications.
The power efficient-ethernet auto command is available only if the interface is EEE capable. To check if
an interface is EEE capable, use the show eee capabilities EXEC command.
When EEE is enabled, the device advertises and autonegotiates EEE to its link partner. To view the current
EEE status for an interface, use the
show eee status EXEC command.
This command does not require a license.
Examples This example shows how to enable EEE for an interface:
Device(config-if)# power efficient-ethernet auto
Device(config-if)#
This example shows how to disable EEE for an interface:
Device(config-if)# no power efficient-ethernet auto
Device(config-if)#
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
57
power efficient-ethernet auto