Cisco Catalyst 3650 Series, Справочник по командам

Страница: 684 / 1108

queue-limit
To specify or modify the maximum number of packets the queue can hold for a class policy configured in a
policy map, use the
queue-limit policy-map class configuration command. To remove the queue packet limit
from a class, use the no form of this command.
queue-limit queue-limit-size [ packets ] { cos cos-value | dscp dscp-value } percent percentage-of-packets
no queue-limit queue-limit-size [ packets ] { cos cos-value | dscp dscp-value } percent percentage-of-packets
Syntax Description
The maximum size of the queue. The maximum varies
according to the optional unit of measure keyword
specified ( bytes, ms, us, or packets). queue-limit-size
Specifies parameters for each cos value. CoS values are
from 0 to 7. cos cos-value
Specifies parameters for each DSCP value.
You can specify a value in the range 0 to 63 specifying
the differentiated services code point value for the type
of queue limit .
dscp dscp-value
A percentage in the range 1 to 100 specifying the
maximum percentage of packets that the queue for this
class can accumulate.
percent percentage-of-packets
Command Default
None
Command Modes
Policy-map class configuration (policy-map-c)
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SE
Usage Guidelines
Although visible in the command line help-strings, the packets unit of measure is not supported; use the
percent
unit of measure.
This command is supported only on wired ports in the egress direction.
Note
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
658
queue-limit