Cisco Catalyst 3650 Series, Справочник по командам

Страница: 358 / 1108

rep preempt segment
To manually start REP VLAN load balancing on a segment, use the rep preempt segment command in
privileged EXEC mode.
rep preempt segment segment-id
Syntax Description
ID of the REP segment. The range is from 1 to 1024. segment-id
Command Default
Manual preemption is the default behavior.
Command Modes
Privileged EXEC (#)
Command History
Modification Release
This command was introduced Cisco IOS XE Denali 16.2.2
Usage Guidelines
Enter this command on the segment, which has the primary edge port on the router.
Ensure that all the other segment configuration is completed before setting preemption for VLAN load
balancing. When you enter the
rep preempt segment segment-id command, a confirmation message appears
before the command is executed because preemption for VLAN load balancing can disrupt the network.
If you do not enter the
rep preempt delay seconds
command in interface configuration mode on the primary
edge port to configure a preemption time delay, the default configuration is to manually trigger VLAN load
balancing on the segment. Use the
show rep topology
privileged EXEC command to see which port in the
segment is the primary edge port.
If you do not configure VLAN load balancing, entering this command results in the default behavior-the
primary edge port blocks all VLANs.
You configure VLAN load balancing by entering the rep block port command in interface configuration
mode on the REP primary edge port before you manually start preemption.
Examples The following example shows how to manually trigger REP preemption on segment 100.
Device# rep preempt segment 100
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
332
rep preempt segment