Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 779 / 1538

1-11
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring LLDP, LLDP-MED, and Wired Location Service
Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
This example shows how to enable NMSP on a switch and to set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 nmsp enable Enable the NMSP features on the switch.
Step 3 nmsp notification interval { attachment |
location } interval-seconds
Specify the NMSP notification interval.
attachment —Specify the attachment notification interval.
location— Specify the location notification interval.
interval-seconds— Duration in seconds before the switch sends the
MSE the location or attachment updates. The range is 1 to 30; the
default is 30.
Step 4 end Return to privileged EXEC mode.
Step 5 show network-policy profile Verify the configuration.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Description
clear lldp counters Reset the traffic counters to zero.
clear lldp table Delete the LLDP neighbor information table.
clear nmsp statistics Clear the NMSP statistic counters.
show lldp Display global information, such as frequency of transmissions, the holdtime for
packets being sent, and the delay time before LLDP initializes on an interface.
show lldp entry entry-name Display information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the
neighbor name.
show lldp interface [ interface-id ] Display information about interfaces with LLDP enabled.
You can limit the display to a specific interface.