Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 450 / 1538

1-48
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Interface Characteristics
Configuring the Cisco eXpandable Power System (XPS) 2200
To return to the RPS 2300 default settings, use these commands:
•
To return to the default name setting (no name is configured), use the power rps switch-number port
rps-port-id name user EXEC command with no space between the quotation marks.
• To return to the default port mode, use the power rps switch-number port rps-port-id active
command.
•
To return to the default port priority, use the power rps switch-number port rps-port-id priority
command.
For more information about using the power rps user EXEC command, see the command reference for
this release.
Configuring the Cisco eXpandable Power System (XPS) 2200
The Cisco XPS 2200 is a standalone power system that you can connect to Catalyst 3560-X and Catalyst
3750-X switches to provide backup power to connected devices or, in a Catalyst 3750-X power stack, to
supply additional power to the power stack budget. The XPS 2200 power ports and internal power
supplies can operate in redundant power supply (RPS) mode or stack power (SP) mode.
For more information about the XPS 2000, see the configuration notes:
http://preview.cisco.com/en/US/docs/switches/power_supplies/xps2200/software/configuration/note/ol
24241.html
Step 2
power rps switch-number port rps-port-id mode { active |
standby }
Specifies the mode of the RPS 2300 port.
The keywords have these meanings:
• switch-number —Specifies the stack member to
which the RPS 2300 is connected. The range
is 1 to 9, depending on the switch member
numbers in the stack. This keyword is supported
only on Catalyst 3750-E switches.
•
port rps-port-id —Specifies the RPS 2300 port.
The range is from 1 to 6.
• mode —Sets the mode of the RPS 2300 port:
–
active —The RPS 2300 can provide the
power to a switch when the switch internal
power supply cannot.
–
standby —The RPS 2300 is not providing
power to a switch.
The default mode for RPS ports is active .
Step 3 power rps switch-number port rps-port-id priority priority Sets the priority of the RPS 2300 port. The range is
from 1 to 6, where 1 is the highest priority and 6 is
the lowest priority.
The default port priority is 6.
Step 4 show env rps Verifies your settings.
Step 5 copy running-config startup-config (Optional) Saves your entries in the configuration
file.
Command Purpose