Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 422 / 1538

1-20
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Interface Characteristics
Using Interface Configuration Mode
Number of Endpoints: 2
Endpoint:
Number: 1
Transfer Type: BULK
Transfer Direction: Device to Host
Max Packet: 512
Interval: 0
Endpoint:
Number: 2
Transfer Type: BULK
Transfer Direction: Host to Device
Max Packet: 512
Interval: 0
This is sample output from the show usb port command:
Switch#
show usb port
Port Number: 0
Status: Enabled
Connection State: Connected
Speed: High
Power State: ON
Using Interface Configuration Mode
The switch supports these interface types:
•
Physical ports—Switch ports and routed ports
• VLANs—Switch virtual interfaces
•
Port channels—EtherChannel interfaces
You can also configure a range of interfaces (see the “Configuring a Range of Interfaces” section on
page 1-22 ).
To configure a physical interface (port), specify the interface type, stack member number (only
Catalyst 3750-X switches), module number, and switch port number, and enter interface configuration mode.
• Type—Gigabit Ethernet (gigabitethernet or gi) for 10/100/1000 Mb/s Ethernet ports, 10-Gigabit
Ethernet (tengigabitethernet or te) for 10,000 Mb/s, or small form-factor pluggable (SFP) module
Gigabit Ethernet interfaces (gigabitethernet or gi).
•
Stack member number—The number that identifies the switch within the stack. The switch number
range is 1 to 9 and is assigned the first time the switch initializes. The default switch number, before
it is integrated into a switch stack, is 1. When a switch has been assigned a stack member number,
it keeps that number until another is assigned to it.
You can use the switch port LEDs in Stack mode to identify the stack member number of a switch.
For information about stack member numbers, see the “Stack Member Numbers” section on
page 1-7 .
• Module number—The module or slot number on the switch that is always 0.
•
Port number—The interface number on the switch. The 10/100/1000 port numbers always begin
at 1, starting with the far left port when facing the front of the switch, for example,
gigabitethernet1/0/1 or gigabitethernet1/0/8.