Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 1441 / 1538

1-19
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Appendix 1 Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Configuration Files
This example shows how to specify a remote username of netadmin1 . Then it copies the configuration
file host2-confg from the netadmin1 directory on the remote server with an IP address of 172.16.101.101
to the startup configuration:
Switch# configure terminal
Switch(config)#
ip rcmd remote-username netadmin1
Switch(config)# end
Switch# copy rcp: nvram:startup-config
Address of remote host [255.255.255.255]?
172.16.101.101
Name of configuration file[rtr2-confg]? host2-confg
Configure using host2-confg from 172.16.101.101?[confirm]
Connected to 172.16.101.101
Loading 1112 byte file host2-confg:![OK]
[OK]
Switch#
%SYS-5-CONFIG_NV:Non-volatile store configured from host2-config by rcp from
172.16.101.101
Uploading a Configuration File By Using RCP
Beginning in privileged EXEC mode, follow these steps to upload a configuration file by using RCP:
This example shows how to copy the running configuration file named switch2-confg to the netadmin1
directory on the remote host with an IP address of 172.16.101.101:
Switch# copy system:running-config rcp://netadmin1@172.16.101.101/switch2-confg
Write file switch-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
Switch#
Command Purpose
Step 1
Verify that the RCP server is properly configured by
referring to the
“Preparing to Download or Upload a
Configuration File By Using RCP” section on page 1-17 .
Step 2 Log into the switch through the console port, the Ethernet
management port, or a Telnet session.
Step 3 configure terminal Enter global configuration mode.
This step is required only if you override the default remote
username (see Steps 4 and 5).
Step 4 ip rcmd remote-username username (Optional) Specify the remote username.
Step 5 end Return to privileged EXEC mode.
Step 6 copy system:running-config
rcp:
[[[ // [ username @ ] location ] / directory ] / filename ]
or
copy nvram:startup-config
rcp:
[[[ // [ username @ ] location ] / directory ] / filename ]
Using RCP, copy the configuration file from a switch running
or startup configuration file to a network server.