Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 1252 / 1538

1-6
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Cache Services By Using WCCP
Configuring WCCP
•
The number of available policy-based routing (PBR) labels are reduced as more interfaces are
enabled for WCCP ingress redirection. For every interface that supports service groups, one label is
consumed. The WCCP labels are taken from the PBR labels. You need to monitor and manage the
labels that are available between PBR and WCCP. When labels are not available, the switch cannot
add service groups. However, if another interface has the same sequence of service groups, a new
label is not needed, and the group can be added to the interface.
• You cannot configure WCCP and VPN routing/forwarding (VRF) on the same switch interface.
•
You cannot configure WCCP and PBR on the same switch interface.
• You cannot configure WCCP and a private VLAN (PVLAN) on the same switch interface.
Enabling the Cache Service
For WCCP packet redirection to operate, you must configure the switch interface connected to the client
to redirect inbound packets.
This procedure shows how to configure these features on routed ports. To configure these features on
SVIs, see the configuration examples that follow the procedure.
Beginning in privileged EXEC mode, follow these steps to enable the cache service, to set a multicast
group address or group list, to configure routed interfaces, to redirect inbound packets received from a
client to the application engine, enable an interface to listen for a multicast address, and to set a
password. This procedure is required.
Note
Before configuring WCCP commands, configure the SDM template, and reboot the switch. For more
information, see
Chapter 1, “Configuring SDM Templates.”