Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 1217 / 1538

1-9
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Cisco IOS IP SLAs Operations
Configuring IP SLAs Operations
Beginning in privileged EXEC mode, follow these steps to configure UDP jitter operation on the source
device:
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 ip sla operation-number Create an IP SLAs operation, and enter IP SLAs configuration mode.
Step 3 udp-jitter { destination-ip-address
| destination-hostname }
destination-port [ source-ip
{ ip-address | hostname }]
[ source-port port-number ]
[ control { enable | disable }]
[ num-packets number-of-packets ]
[ interval interpacket-interval ]
Configure the IP SLAs operation as a UDP jitter operation, and enter UDP
jitter configuration mode.
•
destination-ip-address | destination-hostname —Specify the destination IP
address or hostname.
•
destination-port —Specify the destination port number in the range from 1
to 65535.
•
(Optional) source-ip { ip-address | hostname } — Specify the source IP
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination
• (Optional) source-port port-number —Specify the source port number in
the range from 1 to 65535. When a port number is not specified, IP SLAs
chooses an available port.
•
(Optional) control —Enable or disable sending of IP SLAs control
messages to the IP SLAs responder. By default, IP SLAs control messages
are sent to the destination device to establish a connection with the IP
SLAs responder
• (Optional) num-packets number-of-packets —Enter the number of
packets to be generated. The range is 1 to 6000; the default is 10.
•
(Optional) interval inter-packet-interval —Enter the interval between
sending packets in milliseconds. The range is 1 to 6000; the default value
is 20 ms.
Step 4 frequency seconds (Optional) Set the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 seconds.
Step 5
exit Exit UDP jitter configuration mode, and return to global configuration mode.