Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 1032 / 1538

1-18
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring EtherChannels and Link-State Tracking
Configuring EtherChannels
This example shows how to configure an EtherChannel. It assigns two ports to channel 5 with the LACP
mode
active :
Switch# configure terminal
Switch(config)#
interface range gigabitethernet2/0/1 -2
Switch(config-if-range)# no ip address
Switch(config-if-range)# no switchport
Switch(config-if-range)#
channel-group 5 mode active
Switch(config-if-range)# end
This example shows how to configure a cross-stack EtherChannel. It assigns two ports on stack member
2 and one port on stack member 3 to channel 7 using LACP active mode:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/4 -5
Switch(config-if-range)# no ip address
Switch(config-if-range)# no switchport
Switch(config-if-range)# channel-group 7 mode active
Switch(config-if-range)# exit
Switch(config)# interface gigabitethernet3/0/3
Switch(config-if)# no ip address
Switch(config-if)# no switchport
Switch(config-if)# channel-group 7 mode active
Switch(config-if)# exit
Configuring EtherChannel Load-Balancing
This section describes how to configure EtherChannel load-balancing by using source-based or
destination-based forwarding methods. For more information, see the
“Load-Balancing and Forwarding
Methods” section on page 1-8 .
Beginning in privileged EXEC mode, follow these steps to configure EtherChannel load-balancing. This
procedure is optional.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 port-channel load-balance { dst-ip | dst-mac |
src-dst-ip | src-dst-mac | src-ip | src-mac }
Configure an EtherChannel load-balancing method.
The default is src-mac .
Select one of these load-distribution methods:
• dst-ip —Load distribution is based on the destination-host IP
address.
•
dst-mac —Load distribution is based on the destination-host
MAC address of the incoming packet.
• src-dst-ip —Load distribution is based on the
source-and-destination host-IP address.
•
src-dst-mac —Load distribution is based on the
source-and-destination host-MAC address.
• src-ip —Load distribution is based on the source-host IP
address.
•
src-mac —Load distribution is based on the source-MAC
address of the incoming packet.