11-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 11 Configuring Interface Characteristics
Using Interface Configuration Mode
Enter the
show interfaces
privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface.
Configuring a Range of Interfaces
You can use the
interface range
global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface-range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
When using the
interface range
global configuration command, note these guidelines:
•
Valid entries for
port-range
:
–
vlan
vlan-ID
-
vlan-ID
, where the VLAN ID is 1 to 4094
–
gigabitethernet
module/{first
port
} - {
last port
}, where the module is always 0 (for
nonstacking-capable switches)
gigabitethernet
stack member/module/{first
port
} - {
last port
}, where the module is always 0
(for stacking-capable switches)
–
tengigabitethernet
module/{
first port
} - {
last port
}, where the module is always 0 (for
nonstacking-capable switches)
tengigabitethernet
stack member/module/{
first port
} - {
last port
}, where the module is always
0 (for stacking-capable switches)
–
port-channel
port-channel-number
-
port-channel-number
, where the
port-channel-number
is 1 to 64
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface range
{
port-range
|
macro
macro_name
}
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface-range configuration mode.
•
You can use the
interface range
command to configure up to five
port ranges or a previously defined macro.
•
The
macro
variable is explained in the
Interface Range Macros” section on page 11-11
•
In a comma-separated
port-range
, you must enter the interface
type for each entry and enter spaces before and after the comma.
•
In a hyphen-separated
port-range
, you do not need to re-enter the
interface type, but you must enter a space before the hyphen.
Step 3
Use the normal configuration commands to apply the configuration
parameters to all interfaces in the range. Each command is executed
as it is entered.
Step 4
end
Return to privileged EXEC mode.
Step 5
show interfaces
[
interface-id
]
Verify the configuration of the interfaces in the range.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
