C-1
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
A P P E N D I X
C
Unsupported Commands in
Cisco IOS Release 12.2(52)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the switch prompt but are not supported in this release, either because they are not
tested or because of switch hardware limitations. This is not a complete list. The unsupported commands
are listed by software feature and command mode.
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable
[
host
] [
timeout
minutes
]
access-template
[
access-list-number
|
name
] [
dynamic-name
] [
source
] [
destination
] [
timeout
minutes
]
clear access-template
[
access-list-number
|
name
] [
dynamic-name
] [
source
] [
destination
].
show access-lists rate-limit
[
destination
]
show accounting
show ip accounting
[
checkpoint
] [
output-packets
|
access violations
]
show ip cache
[
prefix-mask
] [
type number
]
Unsupported Global Configuration Commands
access-list rate-limit
acl-index
{
precedence
|
mask
prec-mask
}
access-list dynamic extended
Unsupported Route-Map Configuration Commands
match ip address prefix-list
prefix-list-name
[
prefix-list-name
...]
