Cisco Catalyst 2960 Series, Руководство по настройке

Страница: 755 / 2288

Purpose Command or Action
Enables IP routing. ip routing
Example:
Switch(config)# ip routing
Step 3
Returns to privileged EXEC mode. end
Example:
Switch(config)# end
Step 4
Verifies your entries.
show running-config
Example:
Switch# show running-config
Step 5
(Optional) Saves your entries in the configuration
file. copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 6
Assigning IP Addresses to SVIs
To configure IP routing, you need to assign IP addresses to Layer 3 network interfaces. This enables
communication with the hosts of those interfaces that use IP. IP routing is disabled by default, and no IP
addresses are assigned to SVIs.
An IP address identifies a location to which IP packets can be sent. Some IP addresses are reserved for special
uses and cannot be used for host, subnet, or network addresses. RFC 1166,
“ Internet Numbers, ” contains the
official description of IP addresses.
An interface can have one primary IP address. A mask identifies the bits that denote the network number in
an IP address. When you use the mask to subnet a network, the mask is referred to as a subnet mask. To
receive an assigned network number, contact your Internet service provider.
Follow these steps to assign an IP address and a network mask to an SVI:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
673
Assigning IP Addresses to SVIs