Cisco Catalyst 2960 Series, Руководство по настройке

Страница: 1162 / 2288

Configuring Reverse SSH for Modem Access
To configure Reverse SSH for modem access, perform the steps shown in the “ SUMMARY STEPS ” section
below.
In this configuration, reverse SSH is being configured on a modem used for dial-out lines. To get any of the
dial-out modems, you can use any SSH client and start a SSH session as shown (in Step 10) to get to the next
available modem from the rotary device.
SUMMARY STEPS
1.
enable
2.
configure terminal
3. line line-number ending-line-number
4.
no exec
5. login authentication listname
6. rotary group
7.
transport input ssh
8. exit
9.
exit
10.
ssh -l userid :rotary
{ number } { ip-address }
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode.
enable
Step 1
Example:
Device> enable
• Enter your password if prompted.
Enters global configuration mode. configure terminal
Example:
Device# configure terminal
Step 2
Identifies a line for configuration and enters line configuration mode. line line-number ending-line-number
Example:
Device# line 1 200
Step 3
Disables EXEC processing on a line. no exec
Example:
Device(config-line)# no exec
Step 4
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1080
How to Configure Secure Shell